メインコンテンツにスキップ

手順 3 への変更

- Sam Goldheartによって編集

承認済みの編集 : Sam Goldheart

削除
追加
変更なし

手順ライン

[* black] To get to the 'spine', you must first gently lift off the two plastic strips that run on the edges of the glass.
[* black]
Use a knife to prise them up, they are glued down, and have plastic clips on the outside that allow them to slide towards the rear (usb end) of the scanner once the glue is up. Next prise up the glass from the front (buttons end) of the scanner at both edges.
[* black] To get to the 'spine', you must first gently lift off the two plastic strips that run on the edges of the glass.
[* black]
Use a knife to prise them up, they are glued down, and have plastic clips on the outside that allow them to slide towards the rear (usb end) of the scanner once the glue is up. Next prise up the glass from the front (buttons end) of the scanner at both edges.