メインコンテンツにスキップ

手順 3 への変更

- danによって編集

承認の保留中

削除
追加
変更なし

手順ライン

[* black] 1. Firstly turn over the scanner and remove2. To get to the 'spine', you must first gently lift off the three screwstwo plastic strips that run on the backedges of your scanner whichthe glass. Use a knife to prise them up, they are covered by plastic dark Grey oval strips. This is so you don'tglued down, and have plastic clips on the outside that allow them to turnslide towards the rear (usb end) of the scanner over latter when parts can fall out. These screws holdonce the metal 'spine' in placeglue is up. Next prise up the glass from the front (buttons end) of the scanner at both edges.
[* black] 1. Firstly turn over the scanner and remove2. To get to the 'spine', you must first gently lift off the three screwstwo plastic strips that run on the backedges of your scanner whichthe glass. Use a knife to prise them up, they are covered by plastic dark Grey oval strips. This is so you don'tglued down, and have plastic clips on the outside that allow them to turnslide towards the rear (usb end) of the scanner over latter when parts can fall out. These screws holdonce the metal 'spine' in placeglue is up. Next prise up the glass from the front (buttons end) of the scanner at both edges.