メインコンテンツにスキップ

手順4に変更

Andrew Optimus Goldheartさんによる編集

承認済みの編集 : Andrew Optimus Goldheart

変更なし

手順ライン

[* black] Huzzah! The rear cover is held in place with various welcoming clips instead of fierce adhesive.
[* black] We manageNo tools required to pop the rearthis cover off without a hitch—or so we thought.
[* black] It
off, just some sturdy fingernails. All seems to be going well, until we notice the rear-facing camera, while not adheredcamera lodged in place, nevertheless conforms very tightlythe rear case...
[* black] The camera seems
to fit a little too snuggly in its contours oncubicle in the rear case. Whencase, and got pulled right out of its ZIF connector on the rear case is removed, the camera comes with itmotherboard.
[* black] To make matters worse, the camera connector is on the underside of the motherboard, which means we can'twe'll have to remove the board to reconnect it with easethe camera.
[* black] We manageNo tools required to pop the rearthis cover off without a hitch—or so we thought.
[* black] It
off, just some sturdy fingernails. All seems to be going well, until we notice the rear-facing camera, while not adheredcamera lodged in place, nevertheless conforms very tightlythe rear case...
[* black] The camera seems
to fit a little too snuggly in its contours oncubicle in the rear case. Whencase, and got pulled right out of its ZIF connector on the rear case is removed, the camera comes with itmotherboard.
[* black] To make matters worse, the camera connector is on the underside of the motherboard, which means we can'twe'll have to remove the board to reconnect it with easethe camera.