メインコンテンツにスキップ

手順 8 への変更

- Stacey McKennaによって編集

承認の保留中

削除
追加
変更なし

手順ライン

[* yellow] Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board.
[* black] Remove two screws shown in image ^^74754the second image. Remove the gray connector on top of the input board.
[* black] Remove two screws shown in image ^^74754the second image. Remove the gray connector on top of the input board.
[* violet] Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board. Unclip the component from the logic board.
[* icon_note] Note that there is a clip on both the left and right sides of the input board.