メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

手順6に変更

ABCellarsさんによる編集

承認の保留中

変更なし

手順ライン

[* black] Repeat the above process for the other side of the resistor.
[* black] To complete the discharge tool, strip the ends of the wires.
[* icon_note] To discharge from small points, it may be helpful to cut the exposed ends of wire into a point shape and solder them to maintain the shape. Alternatively, the probes commonly used on multimeters can be soldered to the wires to create a more precise discharge tool. For large electrolytic capacitors used in power supplies, electric motor start circuits and camera flash units you may want to solder 1 end to a large alligator clip and the other to a well insulated screw driver.
[* icon_note] To discharge from small points, it may be helpful to cut the exposed ends of wire into a point shape and solder them to maintain the shape. Alternatively, the probes commonly used on multimeters can be soldered to the wires to create a more precise discharge tool. For large electrolytic capacitors used in power supplies, electric motor start circuits and camera flash units you may want to solder 1 end to a large alligator clip and the other to a well insulated screw driver.