メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

手順4に変更

Andrew Bookholtさんによる編集

承認の保留中

変更なし

手順ライン

[* black] Insert wisdom hereJoin the lead leaving the resistor to the stripped end of the wire by twisting the two together.
[* icon_note] The wire we are using is quite thick, so we inserted the resistor lead down the center of the conductor portion of the wire and twisted the wire against it as tightly as possible.
[* black] Solder the wire to the resistor.
[* icon_caution] It is essential that enough solder flows through the wire to create a permanent bond between the two pieces
.
[* black] Insert wisdom hereJoin the lead leaving the resistor to the stripped end of the wire by twisting the two together.
[* icon_note] The wire we are using is quite thick, so we inserted the resistor lead down the center of the conductor portion of the wire and twisted the wire against it as tightly as possible.
[* black] Solder the wire to the resistor.
[* icon_caution] It is essential that enough solder flows through the wire to create a permanent bond between the two pieces
.