メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

手順2に変更

charles moralesさんによる編集

承認済みの編集 : Nick

変更なし

手順ライン

[* red] Unscrew 8 T10 screws from the cooling unit. G5 models withNOTE: these screws are acctually allen keys. The prefered tool will be long handled allen keys. t10 are 2.74mm (closest allen key is 2.5 or 3mm) and t15 are 3.27mm(closest allen key is 3mm and 4mm). You may strip your tool or the large Fujikura heat sinks (not shown in picture) will have 8 2.5mm hex screwsactual screws themselves. Use a set of high quality long handled allen keys.
[* red] Unscrew 8 T10 screws from the cooling unit. G5 models withNOTE: these screws are acctually allen keys. The prefered tool will be long handled allen keys. t10 are 2.74mm (closest allen key is 2.5 or 3mm) and t15 are 3.27mm(closest allen key is 3mm and 4mm). You may strip your tool or the large Fujikura heat sinks (not shown in picture) will have 8 2.5mm hex screwsactual screws themselves. Use a set of high quality long handled allen keys.
[* icon_note] The screws are somewhat hidden, so they cannot be see in the picture.
[* icon_note] To visualize the location of the screws look 3 steps ahead.
[* black] The screws will loosen but will not come out, they are designed to loosen the unit, but remain in place.