メインコンテンツにスキップ

手順 2 への変更

- Nathan Reeveによって編集

承認済みの編集 : Nathan Reeve

削除
追加
変更なし

手順ライン

[* black] TheThere are three internal wires are connected to the logic board by small end clips. There is one internal wire that is connected by a larger end clip. To release themthe small clips, place the plasticflat end of the plastic spudger underneath the clip and gently lever it '''outward''' to detach it from the connector.
[* black] tttTo release the larger clip, place the flat end of the plastic spudger on the side and lever it '''upward''' to slide it out of its little casing.
[* black] TheThere are three internal wires are connected to the logic board by small end clips. There is one internal wire that is connected by a larger end clip. To release themthe small clips, place the plasticflat end of the plastic spudger underneath the clip and gently lever it '''outward''' to detach it from the connector.
[* black] tttTo release the larger clip, place the flat end of the plastic spudger on the side and lever it '''upward''' to slide it out of its little casing.
[* icon_caution] These clips are fairly delicate and will break if handled roughly. Handle them gently.