メインコンテンツにスキップ

手順 7 への変更

- Joshua Byrneによって編集

承認済みの編集 : Joshua Byrne

削除
追加
変更なし

手順ライン

[title] Replacement Note: Existing Heatsink
[* icon_note] Perform the following steps once you have installed the new processors and ready to re-install the heatsinks.
[* black] Preparing an EXISTING Heatsink for Re-installation. If you have a new heatsink, follow the NEW Heatsink procedure.
[* black] Using the alcohol pad included with the logic board or processor replacement part, clean off any used thermal grease from the processor and the bottom of the heatsink.
[* black] Using the thermal grease included with the logic board or processor replacement part, apply one dot of fresh grease to the raised square area on the bottom of the heatsink.
[* black] Spread the grease evenly across the square to a thickness of approximately 1 mm.
[* icon_caution] Warning: Do not apply more grease than recommended. The grease must not overflow the heatsink and come in contact with the processor connector.

画像1

以前の画像はありません

追加