手順6に変更
手順ライン
| + | [title] Charging |
|---|---|
| + | [* black] Apply a charging profile consistent with the battery datasheet. Varta CP1654. |
| + | [* black] If you lack a battery charger, a low voltage supply through a current limiting resistor can work. Limit charging to 1C rate (<60mA) and increase voltage periodically as battery voltage recovers. |
| + | [* black] If the charge voltage does not raise above a 1V in a few minutes, the cell is most likely damaged beyond repair. |
| + | [* black] DO NOT APPLY VOLTAGE OR CURRENTS GREATER THAN THAT SPECIFIED IN THE DATASHEET. THIS MAY RESULT IN DAMAGE TO THE CELL, ELECTRONICS, OR PERSONAL INJURY! |
| + | [* black] If you do not know how to properly recover the battery, it is recommended that you stop charging at ~3.5V, and allow the onboard charger to complete the rest after re-assembly. |
画像1
以前の画像はありません
追加
画像2
以前の画像はありません
追加