この手順に変更
- Kristen Gismondiによって編集
承認済みの編集 : Kristen Gismondi
- 前
- 後
- 変更なし
手順ライン
| - | [* black] Once the solder is removed, use tweezers to carefully lift and remove the old button modules from the logic board. |
|---|---|
| [* black] Position the new SW2, SW3, and SW4 modules in place where the old ones were located. Make sure they are aligned correctly with the contacts on the logic board. | |
| [* black] Secure the new buttons by resoldering them to the logic board. | |
| [* icon_note] Apply a small amount of new solder to each contact point, ensuring a strong, clean connection. |