Skip to main content

Changes to Step #2

Edit by Andrew Bookholt

承認の保留中

Deleted
Added
Unchanged

Step Lines

[* black] Use the flat end of a spudger to pry the fan connector straight up off the logic board.
[* icon_note] Pry upIt is useful to twist the spudger axially from beneath the wiresfan cable wires to release the connector.
[* icon_caution] The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same
.
[* icon_note] Pry upIt is useful to twist the spudger axially from beneath the wiresfan cable wires to release the connector.
[* icon_caution] The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same
.

Image 2

No previous image

Added

Image 3

No previous image

Added