Skip to main content

Changes to Step #3

Edit by Christopher

承認済みの編集 by Christopher

Deleted
Added
Unchanged

Step Lines

[* red] Using a Phillips #01#1 screwdriver, remove the four 1/4"6.4 mm Phillips #1 screws holding the adapter to the outer case.
[* red] Using a Phillips #01#1 screwdriver, remove the four 1/4"6.4 mm Phillips #1 screws holding the adapter to the outer case.
[* icon_note] Only remove the following screws if you are planning on taking apart the iPod Adapter in a later step:
[* orange] Use a Phillips #01 screwdriver to removeRemove the two 1/4"6.4 mm Phillips #1 screws near the center of the adapter. These screws have built in washers.
[* yellow] Use a Phillips #01 screwdriver to removeRemove the 5/32"4.0 mm Phillips #1 screw from the center of the adapter.
[* orange] Use a Phillips #01 screwdriver to removeRemove the two 1/4"6.4 mm Phillips #1 screws near the center of the adapter. These screws have built in washers.
[* yellow] Use a Phillips #01 screwdriver to removeRemove the 5/32"4.0 mm Phillips #1 screw from the center of the adapter.
[* black] The iPod adapter should now be separate from the upper casing.