手順6に変更
- Wayne Robertsによって編集
承認済みの編集 : Wayne Roberts
- 前
- 後
- 変更なし
手順ライン
| [title] Removing the Vibration Motors And Screws From the Motherboard | |
| [* black] The wires will need to be desoldered from the board, and will be replaced later for reassembly. | |
| [* black] Note: each pair of wires has the black cable soldered to the lower connection; keep this in mind for the reassembly if the pictures from this guide aren't nearby. | |
| + | [* black] Note: You may be able to get away without desoldering these, depending on what you need to reach (credit to @bikemerlin), but due to the simplicity and fragility of these connections, I would suggest removing them to prevent additional damage. |
| [* black] Some of the solder in this controller requires a very high temperature to release. I had mine set to 450 C, however you may be able to remove it at a lower temperature. | |
| [* black] Remove the two T-6 screws from the board near the vibration motors. |