手順14に変更
- Kyle Smithによって編集
承認済みの編集 : Kyle Smith
- 前
- 後
- 変更なし
手順ライン
| - | [* black] Insert the tip of an opening pick under the center of the left edge of the display at a steep angle. |
|---|---|
| - | [* black] Lower the pick so that it is level with the screen. |
| - | [* icon_caution] Make sure the pick is below the display. Inserting the pick between the glass and the display may permanently damage the display. |
| - | [* black] Leave the opening pick in the center of the left edge of the display to prevent the adhesive from resealing. |
| - | [* icon_note] At this point, the perimeter of the display should be separated from the phone. If there are areas where the display is not separated from the phone, slide an opening pick back and forth in that area until separation occurs. |
| + | [* black] Insert the tip of an opening pick under the center of the left edge of the screen at a steep angle. |
| + | [* black] Push down the opening pick so that it is level with the screen. |
| + | [* black] Leave the opening pick in the center of the left edge of the screen to prevent the adhesive from re-sealing. |
| + | [* icon_note] At this point, the perimeter of the screen should be separated from the frame. If there is still resistance around the edges of the screen, use an opening pick to cut the adhesive again. |