手順3に変更
- Philip Le Richeによって編集
承認済みの編集 : Philip Le Riche
- 前
- 後
- 変更なし
手順ライン
| - | [title] |
|---|---|
| + | [title] Take aim! |
| [* red] Take a look at your hard disk. From the lid, you should be able to make out the outline of where the disk is. Note a point half way between the centre of the disk where you will be drilling a hole. | |
| [* orange] Below the disk is the read/write head actuator. | |
| - | [* black] If you have any difficulty working out where that is, or just want to see inside, you can unscrew the lid. |
| - | [* black] You will generally need a Torx screwdriver. There are usually 6 screws around the perimeter of the drive. Remove these. |
| - | [* black] Most laptop drives have one more screw under the label. You will need to locate it by feel, or by viewing it with the light at just the right angle. |
| - | [* black] Scrape away the label from around the screw head, using a craft knife or similar. Under the label there is likeley to be a layer of foil. Scrape this away as well, revealing the screw head. Remove the screw. |
| - | [* black] Desktop drives may have more screws, which you will have to locate and remove in the same way. |
| - | [* black] Once you have remove all the screws you should be able to prise off the lid. A rubber seal may make it a little reluctant to come off. |
| + | [* black] Note a point roughly half way between the centre of the disk and its circumference. This is where you will be doing the damage! |