メインコンテンツにスキップ

手順 7 への変更

- Paul Barnfatherによって編集

承認済みの編集 : Paul Barnfather

削除
追加
変更なし

手順ライン

[title] Timing check
[* black] Fit a new spark plug
[* black] Switch the ignition on. You should see ~3A on the ammeter for about five seconds, before the igniter shuts off the current to the coil.
[* icon_caution] If you see 5A or more, your coil resistance is too low. You need to change the coil for a suitable 4 ohm one to avoid damaging the igniter box.
[* black] Start her up and go for a ride!
[* icon_note] If it kicks back or pinks, it's too advanced. If it pops & bangs on the overrun and lacks power, it's retarded.
[* black] All being well, the engine should pull cleanly and run well... If it feels fine, give it a good thrashing ;-)
[* black] After your ride, pull the spark plug and look carefully at the earth electrode. You're looking for the heat "telltale" mark to be close to the bend. Closer to the plug body = too advanced. Closer to the tip = too retarded. The plug shown in the picture is about right.
[* black] After your ride, pull the spark plug and look carefully at the earth electrode. You're looking for the heat "telltale" mark to be close to the bend. Closer to the plug body = too advanced. Closer to the tip = too retarded. The plug shown in the picture is about right.
[* black] You now have a spare Wipac points plate and advance/retard mechanism. These are almost impossible to find second-hand. Hopefully you won't need them again!