メインコンテンツにスキップ

手順 5 への変更

- Paul Barnfatherによって編集

承認済みの編集 : Paul Barnfather

削除
追加
変更なし

手順ライン

[title] Fit the new rotor & stator
[* black] Fit the rotor and retaining bolt. Don't do it upFinger tight just yetis enough, as you will need to be able to move the rotor to set the timing
[* black] Fit the rotor and retaining bolt. Don't do it upFinger tight just yetis enough, as you will need to be able to move the rotor to set the timing
[* black] Now is a good time to run the Boyer trigger wires. To make life easier, solder the ends of the trigger wires to the old points wire and pull them through the hole in the crankcase. This is much quicker than taking the outer cover off...
[* black] The stator plate should fit snugly into the points plate recess
[* icon_note] I found the Boyer stator was 0.5mm too large to fit into the points plate recess. If you have the same problem, draw a reference mark around the plate and file away the excess