メインコンテンツにスキップ

手順 5 への変更

- Paul Barnfatherによって編集

承認済みの編集 : Paul Barnfather

削除
追加
変更なし

手順ライン

[title] Fit the new rotor & stator
[* black] Fit the rotor and retaining bolt, but don't do it up tight just yet - you will need to move the rotor to set the timing
[* black] Now is a good time to put the Boyer trigger wires through. To make life easier, just solder the ends of the trigger wires to the old points wire and pull them through - this is much simpler than taking the outer cover off...
[* black] I found the Boyer stator was 0.5mm too large to fit into the points plate recess. If you have the same problem, draw a reference mark around the plate and file away the excess
[* black] The points plate should fit snugly into the points plate recess

画像1

古いバージョン

新しいバージョン

画像2

古いバージョン

新しいバージョン

画像3

以前の画像はありません

追加