メインコンテンツにスキップ

手順1に変更

Donald Percivalleさんによる編集

承認済みの編集 : Donald Percivalle

変更なし

手順ライン

+[* red] Locate the switch component in the top portion of the vacuum.
+[* black] Pull it out towards you--it should simply slide out.
+[* orange] Now, disconnect both terminals of the switch by strongly pulling them away from the switch.
+ [* icon_reminder] When installing your new switch, note that this switch does not have polarity (there isn't a wrong way to plug the wires in). However, the wires sit flush in only one wire/terminal combination. The longer wire should plug into the left terminal, and shorter wire should plug into the right terminal.

画像1

以前の画像はありません

追加

画像2

以前の画像はありません

追加