メインコンテンツにスキップ

手順1に変更

Donald Percivalleさんによる編集

承認済みの編集 : Donald Percivalle

変更なし

手順ライン

-[* red] Locate the switch component in the top portion of the vacuum.
-[* black] Pull it out towards you--it should simply slide out.
-[* orange] Now, disconnect both terminals of the switch by strongly pulling them away from the switch.
- [* icon_reminder] When installing your new switch, note that this switch does not have polarity (there isn't a wrong way to plug the wires in). However, the wires sit flush in only one wire/terminal combination. The longer wire should plug into the left terminal, and shorter wire should plug into the right terminal.
+[* black] Remove the other terminal for the power cord that connects to the terminal below the power switch.
+ [* icon_reminder] The terminals will only fit one way when reassembling your vacuum, i.e., the power cord can only be installed one way.

画像1

古いバージョン

新しいバージョン

画像2

削除済み