メインコンテンツにスキップ

手順2に変更

Jasonさんによる編集

承認済みの編集 : Jason

変更なし

手順ライン

-[* black] Remove the plastic slide over each battery case by pressing down firmly and pushing in the direction of the arrows shown above the word "Open" on the plastic.
+[* black] Using your fingers, press down firmly on the plastic slide and push in the direction of the arrows shown above the word "Open" on the plastic.
+[* black] Remove the plastic slide from its location and set it aside.
[* icon_note] These plastic slides are not interchangeable, so make sure each goes back to its original location in reassembly.
-[* black] Remove all 4 AA batteries by placing a fingernail at one end and applying force upwards.
-[* black] Remove the watch battery in the same way.
+[* black] Remove all 4 AA batteries by placing your fingernail at one end of the battery and applying force upwards until the battery is freed from its holder.
+[* black] Set the batteries aside, careful to not get them wet.
+[* black] Insert your fingernail or a prying tool under the notch of the plastic slide that is protecting the watch battery.
+[* black] Apply force in the direction of the arrow shown above the word "Open" on the plastic. The plastic piece covering the watch battery should come loose.
+[* black] Set this plastic covering aside as well.