手順5に変更
- David Albarran-Martinezによって編集
承認済みの編集 : David Albarran-Martinez
- 前
- 後
- 変更なし
手順ライン
| [* black] Flip the drone on its back | |
| - | [* red] Remove the eight 4.5 mm hex screws with a 1.5 mm hex bit. |
| + | [* red] Remove the eight 4.5 mm hex screws by turning them counterclockwise with a 1.5 mm hex bit. |
| [* black] Separate the mesh from the drone by pulling up gently and rocking left to right. | |
| [* icon_caution] The cable connects from the camera to the drone. Pulling up could rip the connection. Tilt the mesh 90 degrees towards the cable. |