メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

手順4に変更

Alec Mさんによる編集

承認済みの編集 : Alec M

変更なし

手順ライン

[title] Lift and remove the rear panel
[* icon_caution] When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board
[* blue] Flip the lock on the flex cable connector up with a spudger.
[* black] The front panel should pop off now that the cable's disconnectedcable has been disconnected.
[* black] The front panel should pop off now that the cable's disconnectedcable has been disconnected.
[* icon_note] When reassembling the device, make sure to insert the left side of the front panel first, since it has a small lip that needs to fit under the left part of the camera case.