メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

手順9に変更

Justinさんによる編集

承認済みの編集 : Justin

変更なし

手順ライン

[* black] Remove the seat back mounting parts on the floor the vehicle.
[* black] This requires the use of the 10 mm triple square driver. Be sure to use a good one here.
[* black] I've tried a number of triple square drivers over the years, mostly with poor results. Good ones are expensive!
[* black] Here's a rather inexpensive triple square driver set (around $30): [http://www.amazon.com/8Pc-Triple-Square-4Mm-16Mm-Set/dp/B000I1Q60O|VIMXZN100 from Amazon]
[* black] I had a set from SK Tools that was very poor - the drivers were very loose when you put them in the bolt head you were trying to remove. They'd slip and strip the head of the bolt. Not recommended!
[* black] Please note that these bolts are extremely tight and difficult to remove. It's not that their just tight, they have lock-tight or something on them that make them hard to remove all together. They don't just "break loose".

画像1

以前の画像はありません

追加

画像2

以前の画像はありません

追加

画像3

以前の画像はありません

追加