メニュー

あなたの設定

私のワークベンチ

お持ちのデバイス用の修理ガイド、交換用パーツやアンサーフォーラムにアクセスする。
カート

カートには何も入っていません。

当社のショップを閲覧する

手順 3 への変更

- Matthew Quandtによって編集

承認の保留中

削除
追加
変更なし

手順ライン

[* black] Allow the lower EMI shield to hang down from the display.
[* red] Remove the four 7.5 mm T10 Torx screws securing the display to the rear case.
[* icon_note] The screws are recessedheavily recessed (about 1" deep in the enclosure), so a thin magnetic screwdriver aids in removal. Most bit drivers are too short to reach these screws.
[* icon_caution] When you reassemble the computer and re-insert these screws, tape them to the tip of your screwdriver to aid in the insertion process, as they tend to fall down into the case and get stuck behind the motherboard if you don't.
[* icon_note] The screws are recessedheavily recessed (about 1" deep in the enclosure), so a thin magnetic screwdriver aids in removal. Most bit drivers are too short to reach these screws.
[* icon_caution] When you reassemble the computer and re-insert these screws, tape them to the tip of your screwdriver to aid in the insertion process, as they tend to fall down into the case and get stuck behind the motherboard if you don't.