メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

手順4に変更

Jake Devincenziさんによる編集

承認済みの編集 : Jake Devincenzi

削除済み
追加
変更なし

手順ライン

[* black] Cut about 3 inch ofinches off the end of the cable.
[* red] To make sure that it was indeed the connector, and not a cracked wire further up, remove the insulation of one set of wires. The Lowriderdevice uses one set for each side. toTo remove the insulation, you can use a boxcutter, a sharp knife, or a lighterlighter, etc.
[* blue] Attach the test lead from any MP3 player, as previously shown. If the reason for the non-functioning headphones was the connector, there should now be sound oncoming from the headphone speaker (driver). In this case, there was. Therefore, it was indeed the audio connector that was broken.
[* black] Cut about 3 inch ofinches off the end of the cable.
[* red] To make sure that it was indeed the connector, and not a cracked wire further up, remove the insulation of one set of wires. The Lowriderdevice uses one set for each side. toTo remove the insulation, you can use a boxcutter, a sharp knife, or a lighterlighter, etc.
[* blue] Attach the test lead from any MP3 player, as previously shown. If the reason for the non-functioning headphones was the connector, there should now be sound oncoming from the headphone speaker (driver). In this case, there was. Therefore, it was indeed the audio connector that was broken.