メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

手順3に変更

Jake Devincenziさんによる編集

承認済みの編集 : Jake Devincenzi

削除済み
追加
変更なし

手順ライン

[* black] With the three screws removed, the driver will simply fold up to reveal the wiring. In this casecase, the color coded wirecode for the wires is Blue for left and Gold for ground.
[* blue] Here is the way I connected some alligator test leads. Use a male-male 3.5 mm stereo cable. Attach one lead to the sleeve, the upper part of the connector, and one lead to either tip (front) or Ring (middle) of the connector.
[* red] Attach some test points to the end of the alligator cables and touch the solder connections of the speaker (driver). In this case, there was clear sound. This determined that there was no signal cominggoing from the connector to the drivers.
[* black] With the three screws removed, the driver will simply fold up to reveal the wiring. In this casecase, the color coded wirecode for the wires is Blue for left and Gold for ground.
[* blue] Here is the way I connected some alligator test leads. Use a male-male 3.5 mm stereo cable. Attach one lead to the sleeve, the upper part of the connector, and one lead to either tip (front) or Ring (middle) of the connector.
[* red] Attach some test points to the end of the alligator cables and touch the solder connections of the speaker (driver). In this case, there was clear sound. This determined that there was no signal cominggoing from the connector to the drivers.