メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

How To Repair Jammed CanoScan LIDE 90 Scannerはじめにへ変更

danさんによる編集

承認の保留中

変更なし
Title
Repairing CanoScan LIDE 90 Casing Spinejammed
Repairing CanoScan LIDE 90 Casing Spinejammed
Introduction
If your scanner gets jammed half way through then it could be that the casing 'spine' is bent [ … ] There is a metal 'spine' that runs the length of the base inside the casing. ThisWhen bent this pushes the scanner head up and into the glass causing the motor to 'lockup' and creating a horrible noise. [ … ] If you open up the scanner and bend it flat again it solves the problem. [ … ] You can tell if it needs this by turning the scanner upside-down and placing a straight object (metal ruler?) along the length of the scanner back. If you can see bowing (dipping or a curve down) towards the center of the back casing, the rail inside is probably bent.
If your scanner gets jammed half way through then it could be that the casing 'spine' is bent [ … ] There is a metal 'spine' that runs the length of the base inside the casing. ThisWhen bent this pushes the scanner head up and into the glass causing the motor to 'lockup' and creating a horrible noise. [ … ] If you open up the scanner and bend it flat again it solves the problem. [ … ] You can tell if it needs this by turning the scanner upside-down and placing a straight object (metal ruler?) along the length of the scanner back. If you can see bowing (dipping or a curve down) towards the center of the back casing, the rail inside is probably bent.
Imageid