メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

iPad 2 Wi-Fi EMC 2560 Front Panel Adhesive Strips Replacementはじめにへ変更

Andrew Optimus Goldheartさんによる編集

承認済みの編集 : Andrew Optimus Goldheart

変更なし
Introduction
Use this guide to replace the adhesive on your iPad to seal the deal on a repair-job well done. [ … ] Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ … ] It is recommended that you peel each adhesive strip as needed, rather than lay them out all at once.
Use this guide to replace the adhesive on your iPad to seal the deal on a repair-job well done. [ … ] Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ … ] It is recommended that you peel each adhesive strip as needed, rather than lay them out all at once.