メインコンテンツにスキップ

Cell Re-balance of Ryobi One+ 18V Li-ion Battery (130501002)はじめにへ変更

edwardbさんによる編集

承認済みの編集 : edwardb

変更なし
Introduction
This guide applies to Ryobi One+18V Li-ion Battery (130501002), but should also have more general application. This guide will show you how to disassembly the battery pack and check the cell balance and rebalance the cells if necessary.
The battery should normally measure about 18V across the terminals (21V max). If it reads about 12V, then it is likely the battery protection circuit has activated because of cell imbalance. (thoseThose were my symptoms.)
The time estimate for this guide is for disassembly and cell balance measurement. Cell rebalance charge time is extra.
CAUTION: Battery disassembly exposes high current circuits. Be careful!
This battery is of 2P5S configuration (sets of 2 parallel cells, 5 sets in a series string). It uses Sanyo 18650 Li-ion cells.
Conclusion
To reassemble your device, follow these instructions in reverse order from step 3.
Public
いいえ
はい
Summary
Battery drill cutting out too soonunder load (or no load)? Or cutting out under load?
If the battery cells are out of balance, the protection circuit will kick in and kill the battery output. This guide will show you how to check the cell balance and rebalance the cells.

フラグ

  • In Progress removed.