はじめに

The Zoom Q3HD is a handy video/audio recording device released in 2010 How to clean the lens from inside

Remove the two screws from the bottom of the device.
  • Remove the two screws from the bottom of the device.

  • Make sure to put your screws in a safe place.

コメントを追加する

Flip the device over and remove the four screws bordering the grate of the device.
  • Flip the device over and remove the four screws bordering the grate of the device.

コメントを追加する

On the front of the device, slide the battery compartment cover off by pushing inward and sliding downward.
  • On the front of the device, slide the battery compartment cover off by pushing inward and sliding downward.

コメントを追加する

Remove the two screws from the lip of the battery compartment.
  • Remove the two screws from the lip of the battery compartment.

コメントを追加する

Remove the final screw from the bed of the battery compartment.
  • Remove the final screw from the bed of the battery compartment.

コメントを追加する

WARNING: Pieces may become loose when you separate the device in half!
  • WARNING: Pieces may become loose when you separate the device in half!

  • Run the pry tool along the edges of the device to begin separating the device in two halves.

コメントを追加する

REMINDER: Pieces may become loose when you separate the device in half! Apply upward pressure to fully separate the device into two halves.
  • REMINDER: Pieces may become loose when you separate the device in half!

  • Apply upward pressure to fully separate the device into two halves.

コメントを追加する

WARNING: If you’re not careful with keeping the screen close to the board, you will rip off the ribbon attaching the screen to the circuit board.
  • WARNING: If you’re not careful with keeping the screen close to the board, you will rip off the ribbon attaching the screen to the circuit board.

  • Lift display screen keeping the top half close to the board.

コメントを追加する

Gently flip the black clip up attaching the ribbon of the screen to the circuit board.
  • Gently flip the black clip up attaching the ribbon of the screen to the circuit board.

コメントを追加する

Gently slide the ribbon from the circuit board, removing the screen.
  • Gently slide the ribbon from the circuit board, removing the screen.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Grace Bently

メンバー登録日: 2014年10月13日

4 ポイント

1ガイドが承認済み

チーム

Ohio State, Team 1-1, Mccook Fall 2014 Ohio State, Team 1-1, Mccook Fall 2014人のメンバー

OSU-MCCOOK-F14S1G1

4 メンバー

1のガイドは作成済み

コメント1件

My zoom q3HD only have the red light turned on when powering up. No display at all. What is happening? How can I claim warranty? I didn't use the device more than a year. Help me

stancalvin - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 11

今までの合計 956