Yuneec ST10 Plus Camera Switch Replacement

はじめに

This guide will provide a step by step process to the removal and replacement of the shoulder buttons controlling the camera or video on the Yuneec ST10 Plus drone controller. The lefthand switch triggers the drone camera to take a snapshot and the righthand switch toggles the recording feature. If either of these functionalities stop working and you’ve troubleshot the problem to the physical switches, this guide can help you to replace the malfunctioning button and resume the functionality of the remote.

Good news: the two switches are connected with cable connectors, so no soldering will be required to replace them!

必要な工具と部品

手順1 Battery

Yuneec ST10 Plus Camera Switch Replacement, Battery: 手順 1、 1の画像 1

Flip the controller upside down to access the battery compartment.
Grab the compartment door and pull down.

編集

手順2

Gently lift the blue tab connected to the battery in order to remove the battery from its housing.

編集

手順3

Yuneec ST10 Plus Camera Switch Replacement: 手順 3、 3の画像 3

To disconnect the battery from the remote, grab the red and black connectors.
Pull gently on connectors until they disconnect.

編集

手順4 Camera Switch

Yuneec ST10 Plus Camera Switch Replacement, Camera Switch: 手順 4、 3の画像 1

Yuneec ST10 Plus Camera Switch Replacement, Camera Switch: 手順 4、 3の画像 2

Yuneec ST10 Plus Camera Switch Replacement, Camera Switch: 手順 4、 3の画像 3

Grab ahold of the top of the black cap on the button with the pliers and pull up forcefully.

編集

手順5

Twist counter clockwise on the silver portion of the device with a pair of pliers.

編集

手順6

Slide the Jimmy underneath the rubber grips and pry upwards.
With your free hand grasp the rubber grips and pull upward to remove it.

編集

手順7

Remove the six 1.3 cm screws located on the back panel of the remote using the 5.5mm hex screw bit.

編集

手順8

Remove the four 6mm screws from the handle using the 4mm hex driver bit.

編集

手順9

Carefully pull up and over on the back panel to remove. Take your time because there are wires connecting the two panels that can easily torn.

編集

手順10

Flip your device.
Once the silver cover holding the switch in place is removed, remove the switch by grabbing it and pulling back towards you.

編集

手順11

Yuneec ST10 Plus Camera Switch Replacement: 手順 11、 3の画像 3

Once the switch is removed, disconnect the switch from the circuit board by pulling the cable from the cable connector.
The cable will come out by pulling it away from you if the bottom of the controller is oriented closer to you.

編集