Yamaha APX-6N Guitar Strings Replacement - iFixit 修理ガイド

はじめに

This guide will teach you how to remove old or damaged strings from a Yamaha APX-6N guitar. It will also teach you how to put the new strings on properly and tie knots at the bridge and head so the strings stay in place.

必要な工具と部品

手順1 Guitar strings

Yamaha APX-6N Guitar Strings Replacement, Guitar strings: 手順 1、 1の画像 1

Loosen the guitar strings by turning the tuning pegs counter clockwise.

手順2

Yamaha APX-6N Guitar Strings Replacement: 手順 2、 1の画像 1

To avoid injury, assure strings are loosened before cutting.
Once the strings are loose, cut them using the wire cutters.
After strings have been cut, remove them by pulling them out of the tuners and the bottom of the bridge.

手順3

Yamaha APX-6N Guitar Strings Replacement: 手順 3、 2の画像 1

Yamaha APX-6N Guitar Strings Replacement: 手順 3、 2の画像 2

Insert the end of the string through the middle of the bridge until four inches comes through.
Wrap the short end of the string around the long end, making a loop.
Put the short end of the string through the loop around three to four times.
Pull both ends of the string until the knot is tight.

手順4

Yamaha APX-6N Guitar Strings Replacement: 手順 4、 2の画像 1

Yamaha APX-6N Guitar Strings Replacement: 手順 4、 2の画像 2

Insert the end of the string into the hole on the correct tuning peg.
Pull the end over the tuning peg and loop under the string. Then push the end of the string under the loop.
Put the end of the string through the loop and pull both ends until the knot is tight.

手順5

Yamaha APX-6N Guitar Strings Replacement: 手順 5、 2の画像 1

Yamaha APX-6N Guitar Strings Replacement: 手順 5、 2の画像 2

Repeat Step 4 for all other strings. Strings should be placed in the tuning pegs in clockwise order. Refer to string packaging for more details.

手順6

Yamaha APX-6N Guitar Strings Replacement: 手順 6、 1の画像 1

Turn the tuning pegs clockwise to tighten each string until the string makes a sound when plucked.
Do not overtighten the strings! Strings may snap and lead to injury.

手順7

Yamaha APX-6N Guitar Strings Replacement: 手順 7、 1の画像 1

After all strings have been replaced, tune the guitar to your desired tuning.
Check the headstock and the bridge for any loose string ends.
If necessary, use the wire cutters to snip off excess string.
The ends of the strings are very sharp.

終わりに

You now have new strings for your guitar!

作成者

3人の作成者と共同で作成されました。

Benjamin

メンバー登録日: 05/10/21

145 ポイント

1ガイドが承認済み

チーム

York University, Team S1-G20, O'Regan Summer 2021 York University, Team S1-G20, O'Regan Summer 2021人のメンバー

YORK-O'REGAN-SU21S1G20

1 メンバー

1のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 6

今までの合計 270