Wolfgang Puck Pie Maker Disassembly

はじめに

The Wolfgang Puck Pie Maker was released in 2012 by WP Appliances. It has since been discontinued. After frequent use, many users of the device have claimed that there is uneven heating caused by shifts in the heating coil. All the wiring is internally located and requires a #2 Phillips head screwdriver to access. If the device has been used recently, the inside may still be very hot.

必要な工具と部品

手順1 Wolfgang Puck Pie Maker Disassembly

Wolfgang Puck Pie Maker Disassembly, Wolfgang Puck Pie Maker Disassembly: 手順 1、 1の画像 1

Open up the pie maker using the two main handles so it's open as shown in the picture.

編集

手順2

Remove the four 12.7 mm screws from each handle using a Phillips #2 screwdriver.
Remove the inside handle cover.

編集

手順3

Remove the two 12.7 mm screws from the base of the pie maker using a Phillips #2 screwdriver.
This will allow for visibility into the wiring in the base.

編集

手順4

Remove the four 15.9 mm screws from the hinges using a Phillips #2 screwdriver.
Remove the top cover by pulling it off of the device.

編集

手順5

You now have access to the wiring underneath the top and bottom of the device.
To access the wiring, lift the metal burner part out of the base. The wiring will be visible on the opposite side, attached to the heating coil.
The temperature sensor can be accessed by lifting the bottom side of the device as shown.