はじめに

Use this guide to replace the outer case on your Nintendo Wii U GamePad.

  1. Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.
    • Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.

    • Lift up and remove the battery cover.

    コメントを追加する

  2. With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.
    • With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.

    • Pull upwards from the bottom of the battery to release it.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Remove the ten 8.9mm Tri-wing Y1 screws hidden underneath square stickers.

    • Lift up the back plate.

    • The back plate is still connected by a cable to the motherboard.

    how do i replace the whole front and back casing?

    enbodylin - 返信

    • Unplug the connector that connects the back plate to the motherboard.

    • Remove the back plate.

    You don't have to remove just be careful

    Heather Sheppard - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

8 の人々がこのガイドを完成させました。

Kim Arre

メンバー登録日: 2013年01月11日

3,156 ポイント

8のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

113 メンバー

7,342のガイドは作成済み

コメント1件

This is either incomplete or mistitled - it is a currently a back plate replacement guide.

At the conclusion of this how-to/walkthrough, most of the GamePad's hardware is still attached to the front plate, one half of the outer case.

Elijah - 返信

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 10

過去 30 日: 78

今までの合計 9,250