メインコンテンツにスキップ

はじめに

If your Smartwatch is not charging, and you tested the cables, then the battery may need to be replaced. This guide will show you how to do this.

  1. Begin by flipping the watch over with its back facing upwards. Begin by flipping the watch over with its back facing upwards.
    • Begin by flipping the watch over with its back facing upwards.

  2. Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate. Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.
    • Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

  3. Gently lift the backplate up to remove it. Gently lift the backplate up to remove it.
    • Gently lift the backplate up to remove it.

  4. iPhone X用修理キット

    Warranty up? No worries, we’ve got the fix.

    ショップを見る

    iPhone X用修理キット

    Warranty up? No worries, we’ve got the fix.

    ショップを見る
  5. After removing the backplate, lift the master switch up from the circuit board. After removing the backplate, lift the master switch up from the circuit board. After removing the backplate, lift the master switch up from the circuit board.
    • After removing the backplate, lift the master switch up from the circuit board.

  6. Using a Phillips #00 screwdriver,  remove the 0.6 mm screw.
    • Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

  7. Carefully remove the speaker from the case without disconnecting it from the motherboard. Carefully remove the speaker from the case without disconnecting it from the motherboard.
    • Carefully remove the speaker from the case without disconnecting it from the motherboard.

  8. Using the tweezers, carefully lift the bar holding the connection to the screen. Remove the motherboard from the device.
    • Using the tweezers, carefully lift the bar holding the connection to the screen.

    • Remove the motherboard from the device.

  9. Carefully pry the battery off of the circuit board using the plastic opening tool.
    • Carefully pry the battery off of the circuit board using the plastic opening tool.

  10. De-solder the wires connecting the battery to the circuit board.
    • De-solder the wires connecting the battery to the circuit board.

    • Remove the battery.

まとめ

To reassemble your device, follow these instructions in reverse order.

Jessica Richard

メンバー登録日: 2018年10月25日

479 ポイント

4のガイドは作成済み

チーム

UMass Dartmouth, Team S3-G5, Peak Fall 2018 UMass Dartmouth, Team S3-G5, Peak Fall 2018人のメンバー

UMASSD-PEAK-F18S3G5

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 4

過去 7 日: 24

過去 30 日: 94

今までの合計 505