メインコンテンツにスキップ

はじめに

You may need to replace the light mount on your bicycle because the light has burned out or you require a brighter light. This guide shows the proper steps to install a replacement Light Mount for a Trek 820 (or similar) bicycle. No tools are necessary for this easy repair.

ツール

ツールは指定されていません。

パーツ

  1. Clean the area where the light mount will be installed with a soft cloth. Placing the light mount close to the center stem.
    • Clean the area where the light mount will be installed with a soft cloth.

    • Placing the light mount close to the center stem.

  2. Remove the strap from the light mount fitting.
    • Remove the strap from the light mount fitting.

    • Stretch the strap clockwise around the handlebars.

  3. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  4. Slide the strap through the slot and fasten to a snug, but moveable fit.
    • Slide the strap through the slot and fasten to a snug, but moveable fit.

    • Do not fasten too tight as this will make it difficult to fine tune light mount placement.

  5. Pull the strap tightly through the clasps at the bottom of the mount.
    • Pull the strap tightly through the clasps at the bottom of the mount.

  6. Place the fastening screw in the rear screw port on the light mount. Twist the screw clockwise using your hands until fully fastened.
    • Place the fastening screw in the rear screw port on the light mount.

    • Twist the screw clockwise using your hands until fully fastened.

まとめ

Now you have a light mount ready for safer night rides on your Trek bicycle!

Kaveh Karimiyanha

メンバー登録日: 2012年09月24日

759 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 1-1, Propen Fall 2012 Cal Poly, Team 1-1, Propen Fall 2012人のメンバー

CPSU-PROPEN-F12S1G1

5 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 3

今までの合計 698