はじめに

If your hard drive is malfunctioning or if you want to replace it, this guide will show you how to take it out.

パーツ

パーツは必要ありません。

Flip the laptop over so the bottom is facing upward and the battery is on top. Slide the tab below the battery to the left.
  • Flip the laptop over so the bottom is facing upward and the battery is on top.

  • Slide the tab below the battery to the left.

コメントを追加する

Slide and hold the tab on the right side of the battery to the right. While holding the right tab, slide the battery upward and out its socket.
  • Slide and hold the tab on the right side of the battery to the right.

  • While holding the right tab, slide the battery upward and out its socket.

コメントを追加する

Use a #1 Phillips screwdriver to take out the 8mm Phillips #1 screw holding the hard drive panel on.
  • Use a #1 Phillips screwdriver to take out the 8mm Phillips #1 screw holding the hard drive panel on.

コメントを追加する

Place one finger under the tab of the hard drive panel and lift up with medium force.
  • Place one finger under the tab of the hard drive panel and lift up with medium force.

コメントを追加する

Hold the black tab attached to the hard drive and pull with medium force to the side that the tab is on. This will pull the hard drive out of it's socket. Hold the black tab attached to the hard drive and pull with medium force to the side that the tab is on. This will pull the hard drive out of it's socket.
  • Hold the black tab attached to the hard drive and pull with medium force to the side that the tab is on. This will pull the hard drive out of it's socket.

コメントを追加する

Use a #1 Phillips screwdriver to unscrew the four 4mm Phillips #1 screws (2 on each side) holding the brackets to the hard drive. With the screws undone, the brackets should come right off. Next, pull on the black tab again to pull the cover off of the hard drive.
  • Use a #1 Phillips screwdriver to unscrew the four 4mm Phillips #1 screws (2 on each side) holding the brackets to the hard drive.

  • With the screws undone, the brackets should come right off. Next, pull on the black tab again to pull the cover off of the hard drive.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Andrew Meyer

メンバー登録日: 2014年02月03日

239 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 2-8, Amido Winter 2014 Cal Poly, Team 2-8, Amido Winter 2014人のメンバー

CPSU-AMIDO-W14S2G8

4 メンバー

7のガイドは作成済み

コメント1件

There is a missing step between 4 and 5.

- Remove the screw(s) that hold the HDD assembly in its compartment.

...only then can you move on to step 5.

Robert Cartier - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 656