Unlatch the battery by pushing outward on both latches.
  • Unlatch the battery by pushing outward on both latches.

コメントを追加する

Slide battery out.
  • Slide battery out.

コメントを追加する

  • Remove the five "F2" screws with a Phillips #0 screwdriver.

コメントを追加する

  • Insert the plastic opening tool above the F1 key.

  • Apply upward pressure until the black plastic strip snaps off. The entire strip will easily come off from left to right.

コメントを追加する

  • Find the screws above the F1 and INS keys.

  • Unscrew both screws with a Phillips #0 screwdriver.

コメントを追加する

  • Slowly lift the top edge of the keyboard out with your fingers.

  • The ribbon cable located on the back of the keyboard will become accessible.

コメントを追加する

  • Locate the black ribbon cable flap.

  • Detach flap with plastic opening tool. The ribbon cable will become free.

コメントを追加する

  • Your keyboard has now been successfully removed.

コメントを追加する

  • Remove the back panel by removing the three labeled screws with a Phillips #0 screwdriver.

コメントを追加する

  • Locate and remove the circled screw with a Phillips #0 screwdriver.

コメントを追加する

  • Use the plastic opening tool to pry the CD/DVD drive out of the frame.

コメントを追加する

  • Gently remove the CD/DVD drive from the laptop body.

コメントを追加する

  • Remove the circled screws with Phillips #0 screwdriver.

コメントを追加する

  • Remove these screws from the underside of the laptop with Phillips #0 screwdriver.

コメントを追加する

  • Disconnect the three circled antennas by lightly pulling upward with your fingers. They should detach easily.

  • Note: Yours may only have two (2) antennas. Pay attention to the Orientation of the Aluminum bracket with the pads for reinstallation.

コメントを追加する

  • Remove the circled screw with a Phillips #0 screwdriver.

コメントを追加する

  • Detach the 3 marked cables by pulling them out with you fingers as shown.

  • This may require some force. They do not come out easily.

コメントを追加する

  • Detach the four blue ribbon cables carefully with tweezers. Some of the ribbons may require a flap to be raised because it secures the ribbon in.

コメントを追加する

  • Remove the top plastic cover by lifting upward from the bottom left-hand corner as shown. The cover will come off easily.

コメントを追加する

  • Remove the circled motherboard screws with a Phillips #0 Scewdriver.

  • Disconnect this ribbon cable.

コメントを追加する

  • Remove these screws with a Phillips #0 screwdriver.

コメントを追加する

  • Detach the display cable by gently pulling it out with your fingers.

コメントを追加する

  • Remove the motherboard from the left side by gently lifting the left side upward.

  • The boxed volume control may snag on the laptop frame when pulling the motherboard out.

コメントを追加する

  • The motherboard has now been removed from laptop.

コメントを追加する

  • Detach the fan power cord by pulling it out with your fingers.

  • Carefully lift up the tape on the fan by peeling the right edge to the left. It can remain attached to the heatsink but should be removed from the fan.

コメントを追加する

  • Remove the circled screws with a Phillips #0 screwdriver.

コメントを追加する

  • Locate the 3 circled clips holding the fan to the motherboard.

  • Pry each clip outward while applying upward force on the fan as shown.

コメントを追加する

  • Carefully pull out the fan.

  • Note: replacing the fan is highly reccomended

  • Optionally you may clean the fan with Air + Q-Tips. To remove the blade turn the fan over and gently pull the fan blade from the housing.

  • If the fan is no longer operational, it may be possible to temporarily repair it by removing the fan blade and put a small amount of WD-40 on the pinion shaft hole the fan rotates in. A toothpick is a good applicator. Do NOT contaminate the motor area with any of the dust/grime that has accumulated.

  • Insert the fan blade and move the blades with your finger. It should spin freely and cog to a stop. Again this is a temporary fix!

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Michael Jensen

メンバー登録日: 2011年04月18日

417 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 4-3, Regan Spring 2011 Cal Poly, Team 4-3, Regan Spring 2011人のメンバー

CPSU-REGAN-S11S4G3

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 5,739