はじめに

Before starting any removal or installation, remember to turn off the device and to remove it from the power source.

  1. Before repairing your laptop, power down the system, disconnect the charger if necessary and remove the battery.
    • Before repairing your laptop, power down the system, disconnect the charger if necessary and remove the battery.

    • Use the flat edge of the plastic opening tool to pry open the narrow plastic strip above the keyboard.

    コメントを追加する

  2. Remove the three 3mm screws with a Phillips#00 Screwdriver.
    • Remove the three 3mm screws with a Phillips#00 Screwdriver.

    コメントを追加する

    • Lift the keyboard away from the top side of the laptop.

    • Do not pull the keyboard away too hard. It is still connected by the fragile ribbon cable (shown in the red square).

    コメントを追加する

    • Disconnect the keyboard cable that is still attached to the keyboard (Red).

    • Unlatch the fastener (green).

    • Using your hands, pull the keyboard connector out, not up.

    コメントを追加する

    • Flip the laptop over to access the battery.

    • Remove battery by sliding fingers away from each other and lifting up the tab at the same time.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Remove the twelve 10mm screws with a Phillips #00 Head screwdriver.

    • Remove the Cover over the Hard Drive (Upper right in photo) and remove the four 10mm screws at the four corners.

    コメントを追加する

    • Remove the three 4mm screws with a Phillips #00 Screwdriver.

    コメントを追加する

    • Flip the laptop over so its in the right-side-up position.

    • Lift the grey plastic casing up and unhook any wires attached to the casing.

    • Remove the five 10mm screws, each with a label 'F10' next to them.

    コメントを追加する

    • Disconnect the flat thin wire connecting the track pad to the motherboard by pulling it straight out.

    • Disconnect the thin red wire on the right side of the motherboard.

    コメントを追加する

    • Remove the two 6mm screws with a Phillips #00 Screwdriver.

    コメントを追加する

    • Disconnect the red and yellow wires connecting the fan to the motherboard by pulling the wires straight out.

    • Remove the fan.

    コメントを追加する

    • Remove the following with a Phillips #00 Screwdriver:

      • Six 7mm Phillips Head screws

      • One 5 mm Phillips Head screw

    • Remove the LCD screen tab

    コメントを追加する

    • A red wire connects the motherboard to the computer, so release the wire by pulling it straight out.

    • After all the screws are removed, lift the motherboard up and away from the earphone jacks that are located at the front of the laptop.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Mike Kennedy

メンバー登録日: 2013年04月18日

118 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 2-21, Maness Spring 2013 Cal Poly, Team 2-21, Maness Spring 2013人のメンバー

CPSU-MANESS-S13S2G21

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 20

今までの合計 2,209