Make sure the device is off to prevent data loss. Slide both latches to the unlocked position to release the battery.
  • Make sure the device is off to prevent data loss.

  • Slide both latches to the unlocked position to release the battery.

  • Switch the latch on the right to reveal red. The latch on the left needs to be held.

  • Pull the battery toward you while holding the left latch.

コメントを追加する

Remove the sixteen screws at the locations shown with the Phillips 00 screwdriver.
  • Remove the sixteen screws at the locations shown with the Phillips 00 screwdriver.

コメントを追加する

Pull up on the back casing and remove it, revealing the audio/usb port. Pull up on the back casing and remove it, revealing the audio/usb port.
  • Pull up on the back casing and remove it, revealing the audio/usb port.

コメントを追加する

Remove the single 4 mm screw holding the port in place with the Phillips 00 screwdriver.
  • Remove the single 4 mm screw holding the port in place with the Phillips 00 screwdriver.

コメントを追加する

Use the plastic opening tool to disconnect the port from its power source on the laptop. This will be the wire connector with the white connection.
  • Use the plastic opening tool to disconnect the port from its power source on the laptop. This will be the wire connector with the white connection.

コメントを追加する

Remove the ribbon cable from the port to free it from the laptop.
  • Remove the ribbon cable from the port to free it from the laptop.

  • Be careful when reconnecting the ribbon cable, it can be difficult.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

JRJones

メンバー登録日: 2013年04月19日

121 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 2-19, Maness Spring 2013 Cal Poly, Team 2-19, Maness Spring 2013人のメンバー

CPSU-MANESS-S13S2G19

3 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 5

過去 30 日: 7

今までの合計 756