Start by first removing the battery. Move the first release switch to the right position.
  • Start by first removing the battery.

  • Move the first release switch to the right position.

  • Move the second release switch to the right position while pulling the battery towards the top of the netbook.

コメントを追加する

Using the bit driver and a Phillips #0 bit, remove the three circled screws, 5 mm in length.
  • Using the bit driver and a Phillips #0 bit, remove the three circled screws, 5 mm in length.

コメントを追加する

While holding the top of the netbook, flip the netbook over. While holding the top of the netbook, flip the netbook over.
  • While holding the top of the netbook, flip the netbook over.

コメントを追加する

Carefully lift off the power bar assembly for access to the button and receiver. Carefully lift off the power bar assembly for access to the button and receiver.
  • Carefully lift off the power bar assembly for access to the button and receiver.

コメントを追加する

Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body.
  • Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body.

コメントを追加する

Reach under the keyboard and disconnect the electrical connection. Lift the keyboard assembly out and away from the netbook.
  • Reach under the keyboard and disconnect the electrical connection.

  • Lift the keyboard assembly out and away from the netbook.

コメントを追加する

Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool. Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool.
  • Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool.

コメントを追加する

Remove this electrical connection with tweezers. Use a spudger to gently pry the bezel from retaining clips.
  • Remove this electrical connection with tweezers.

  • Use a spudger to gently pry the bezel from retaining clips.

  • This will allow the keyboard bezel to lift off of the body.

コメントを追加する

Use tweezers to remove the electrical connection to the old speaker assembly.
  • Use tweezers to remove the electrical connection to the old speaker assembly.

コメントを追加する

Use a bit driver and a Phillips #0 bit to remove the two retaining screws on the speaker assembly. Lift out the old speaker assembly.
  • Use a bit driver and a Phillips #0 bit to remove the two retaining screws on the speaker assembly.

  • Lift out the old speaker assembly.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

メンバー登録日: 2013年10月18日

943 ポイント

9のガイドは作成済み

チーム

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013人のメンバー

CLEM-BENSON-F13S14G2

3 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 324