Power down the TiVo and detach the power cable from the rear of the unit.
  • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

コメントを追加する

Remove the five T10 screws from the rear of the case using the Torx screwdriver.
  • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

コメントを追加する

Lift up and pull back the outer casing towards the rear of the unit. Lift up and pull back the outer casing towards the rear of the unit.
  • Lift up and pull back the outer casing towards the rear of the unit.

I have the TiVo Series 2 model TCD746500 and the procedure for replacing a fan on my model is almost identical to the procedure described here, with one significant difference at this step: first pull/slide the outer casing back towards yourself and only thereafter pull it up.

Oscar Abraham Jaeger - 返信

The fan is held in by four T15 screws on the rear of the device.
  • The fan is held in by four T15 screws on the rear of the device.

コメントを追加する

Take the wound red and black wires coming from the fan and follow them back to the logic board. Unplug the connector from the motherboard.
  • Take the wound red and black wires coming from the fan and follow them back to the logic board.

  • Unplug the connector from the motherboard.

コメントを追加する

Pull the fan towards the front and out of the TiVo unit. Pull the fan towards the front and out of the TiVo unit.
  • Pull the fan towards the front and out of the TiVo unit.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Svyatoslav Markeyev

メンバー登録日: 2010年04月16日

135 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 33-79, Johann Spring 2010 Cal Poly, Team 33-79, Johann Spring 2010人のメンバー

CPSU-JOHANN-S10S33G79

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 7

今までの合計 5,045