はじめに

In case your remote just won't work and you have already tried replacing the batteries, this guide will walk you through removing the front cover and replacing the remote sensor on the inside of the cover.

パーツ

パーツは必要ありません。

  1. Unscrew the five 0.31 inch T-9 screws on the back cover.
    • Unscrew the five 0.31 inch T-9 screws on the back cover.

  2. Slide the cover towards the back until it is no longer under the front cover.
    • Slide the cover towards the back until it is no longer under the front cover.

  3. Lift the cover up and off the device.
    • Lift the cover up and off the device.

  4. Pro Tech ツールキットを含むご注文、もしくは総額 $100ドル以上のご注文については送料無料です。

    当社のショップを閲覧する
  5. Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.
    • Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.

  6. Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.
    • Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.

  7. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.
    • Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.

  8. Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.
    • Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.

  9. Unscrew the two 0.31 inch T-9 screws on the back of the sensor.
    • Unscrew the two 0.31 inch T-9 screws on the back of the sensor.

  10. Lift the sensor up to remove it.
    • Lift the sensor up to remove it.

まとめ

To reassemble your device, follow these instructions in reverse order.

Shauna

メンバー登録日: 2011年10月10日

37 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 5-33, Amido Fall 2011 Cal Poly, Team 5-33, Amido Fall 2011人のメンバー

CPSU-AMIDO-F11S5G33

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 907