メインコンテンツにスキップ

はじめに

The hard drive is the component capable of storing recordings. This information is vital in case the TiVo does not record the desired shows.

パーツ

パーツは指定されていません。

  1. Power down the TiVo Premiere XL4 by detaching the power cable from the unit and power source.
    • Power down the TiVo Premiere XL4 by detaching the power cable from the unit and power source.

    • Allow the box to cool for at least 5 minutes before proceeding to the next step.

  2. Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver. Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver.
    • Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver.

  3. Take the outer casing by sliding the top of the box off of the component carefully, making sure not to damage the surrounding components inside.
    • Take the outer casing by sliding the top of the box off of the component carefully, making sure not to damage the surrounding components inside.

  4. Android 修理キット

    A new screen or battery is one kit away.

    ショップを見る

    Android 修理キット

    A new screen or battery is one kit away.

    ショップを見る
  5. Pinch the connector of the bundle of wires (the bundle having black, red, black and yellow wires) and gently remove from the motherboard. Pinch the connector of the single flat wire and gently remove from motherboard. Pinch the connector of the single flat wire and gently remove from motherboard.
    • Pinch the connector of the bundle of wires (the bundle having black, red, black and yellow wires) and gently remove from the motherboard.

    • Pinch the connector of the single flat wire and gently remove from motherboard.

  6. Unscrew the following two 80 mm T10  screws connecting the hard drive to the bottom of the box using the Torx screwdriver. Repeat on the other side of the hard drive.
    • Unscrew the following two 80 mm T10 screws connecting the hard drive to the bottom of the box using the Torx screwdriver.

    • Repeat on the other side of the hard drive.

    • There will be a total of four 80 mm T10 screws removed.

  7. Remove hard drive from box.
    • Remove hard drive from box.

  8. Remove the marked (2) T10 screws and washers using a Torx Screwdriver.
    • Remove the marked (2) T10 screws and washers using a Torx Screwdriver.

    • Repeat on the opposite side for (2) T10 screws.

    • Remove the connecting cable.

    • Keep the fasteners if the hard drive needs to be replaced.

まとめ

To reassemble your device, follow these instructions in reverse order.

Frances Prewitt

メンバー登録日: 2018年10月22日

637 ポイント

6のガイドは作成済み

チーム

Baylor, Team S1-G1, Williams Fall 2018 Baylor, Team S1-G1, Williams Fall 2018人のメンバー

BU-WILLIAMS-F18S1G1

3 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 7

今までの合計 118