メインコンテンツにスキップ

Teenage Engineering OP-Z Rubber Feet Replacement

必要な工具と部品

  1. Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 手順 1、 3の画像 1 Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 手順 1、 3の画像 2 Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 手順 1、 3の画像 3
    • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

    • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

  2. Teenage Engineering OP-Z Rubber Feet Replacement: 手順 2、 2の画像 1 Teenage Engineering OP-Z Rubber Feet Replacement: 手順 2、 2の画像 2
    • When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

    • If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

  3. Teenage Engineering OP-Z Rubber Feet Replacement: 手順 3、 1の画像 1
    • Remove the bottom plate including the rubber feet.

  4. Teenage Engineering OP-Z Rubber Feet Replacement, Rubber Feet: 手順 4、 1の画像 1
    • Remove the four Phillips #0 screws from the back of the rubber feet.

  5. Teenage Engineering OP-Z Rubber Feet Replacement: 手順 5、 2の画像 1 Teenage Engineering OP-Z Rubber Feet Replacement: 手順 5、 2の画像 2
    • Separate the front and rear part of the rubber feet from the back cover.

  6. Teenage Engineering OP-Z Rubber Feet Replacement: 手順 6、 1の画像 1
    • When reassembling make sure to correctly align the front and rear part of the rubber feet. The notch and grove should interlock and fit into the cutout of the back cover.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Tobias Isakeit

メンバー登録日: 03/31/14

117,588 ポイント

188のガイドは作成済み

チーム

Master Techs Master Techs人のメンバー

Community

322 メンバー

2,528のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 22

今までの合計 1,583