Teenage Engineering OP-Z Expansion Module Replacement - iFixit 修理ガイド

はじめに

Use this guide to remove the expansion module in the OP-Z.

手順1 Back Cover

Teenage Engineering OP-Z Expansion Module Replacement, Back Cover: 手順 1、 3の画像 1

Teenage Engineering OP-Z Expansion Module Replacement, Back Cover: 手順 1、 3の画像 2

Teenage Engineering OP-Z Expansion Module Replacement, Back Cover: 手順 1、 3の画像 3

Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.
There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

手順2

Teenage Engineering OP-Z Expansion Module Replacement: 手順 2、 2の画像 1

Teenage Engineering OP-Z Expansion Module Replacement: 手順 2、 2の画像 2

When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).
If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

手順3

Teenage Engineering OP-Z Expansion Module Replacement: 手順 3、 1の画像 1

Remove the bottom plate including the rubber feet.

手順4 Expansion Module

Teenage Engineering OP-Z Expansion Module Replacement, Expansion Module: 手順 4、 2の画像 1

Teenage Engineering OP-Z Expansion Module Replacement, Expansion Module: 手順 4、 2の画像 2

Use your finger or a spudger to push up on the small tab on the bottom of the module.
Lift the module up and out of its recess bottom first.

手順5

Teenage Engineering OP-Z Expansion Module Replacement: 手順 5、 1の画像 1

Remove the module.
When inserting another module make sure you put it in outputs first. Then push down the bottom part for the tab to engage.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Tobias Isakeit

メンバー登録日: 03/31/14

117,598 ポイント

188のガイドは作成済み

+43 個以上のバッジ

チーム

Master Techs Master Techs人のメンバー

Community

322 メンバー

2,534のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 13

今までの合計 884