メインコンテンツにスキップ

TDK Life on Record Trek 360 Air Vent Tube Replacement

必要な工具と部品

  1. TDK Life on Record Trek 360 Air Vent Tube Replacement, Disassembling TDK Life on Record bottom panel: 手順 1、 1の画像 1
    • Remove the four rubber feet of the device using a metal spudger.

  2. TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 2、 2の画像 1 TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 2、 2の画像 2
    • Remove the four 9 mm Phillips #0 screws located under the feet of the device.

    • Remove the four 9 mm Torx #8 screws located on each side of the bottom the device.

  3. TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 3、 2の画像 1 TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 3、 2の画像 2
    • Pull the bottom cover of the device towards you.

  4. TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 4、 2の画像 1 TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 4、 2の画像 2
    • Remove the four 13 mm Phillips #1 screws.

  5. TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 5、 2の画像 1 TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 5、 2の画像 2
    • Use one hand to grip the device from the side of the handle, and use the other hand to grip the side of the device that contains the woofer

    • The woofer is the circular component located at the bottom of the device after the bottom cover has been removed

    • Pull apart the compartments by applying force in opposite directions.

    • Do not pull with extreme force!! There are many electrical wires inside the device that can become damaged if the bottom panel is removed without care

  6. TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 6、 1の画像 1
    • Disconnect the seven cables attached to the motherboard.

    • Do not use too much force when pulling on the wires. Pulling with too much force can damage the wires.

  7. TDK Life on Record Trek 360 Air Vent Tube Replacement, Air Vent Tube: 手順 7、 1の画像 1
    • Remove the four 8 mm Phillips #1 screws.

  8. TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 8、 3の画像 1 TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 8、 3の画像 2 TDK Life on Record Trek 360 Air Vent Tube Replacement: 手順 8、 3の画像 3
    • place your hands on each side of the air vent and then place your index finger on the thin plastic half circle that holds the vent in place.

    • Pull the plastic half circle towards you.

    • Put both of your hands inside the tube as shown and push away from you.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

3人の作成者と共同で作成されました。

Helen Huynh

メンバー登録日: 09/14/15

338 ポイント

3のガイドは作成済み

チーム

CSU Fullerton, Team 1-2, Bruce Fall 2015 CSU Fullerton, Team 1-2, Bruce Fall 2015人のメンバー

CSUF-BRUCE-F15S1G2

3 メンバー

5のガイドは作成済み

コメント 1 件

Where can I get a new motherboard?

american1gigolo - 返信

コメントを追加

統計データ:

過去 24時間: 2

過去 7 日: 2

過去 30 日: 6

今までの合計 699