はじめに

This is a prerequisite guide for replacing all of the Staples 34462 Electric Pencil Sharpener's parts. Or maybe your cover is just cosmetically damaged and you want to replace it. Follow the steps below to remove the cover for replacement.

Pull out the shavings tray from the pencil sharpener.
  • Pull out the shavings tray from the pencil sharpener.

  • Beware of loose pencil shavings falling on your workspace.

コメントを追加する

Turn the pencil sharpener on its side.
  • Turn the pencil sharpener on its side.

コメントを追加する

  • Using a Phillips00 screwdriver, remove the two front 11.6mm screws.

  • Using the plastic opening tool, remove the back plastic feet.

  • After removing the back plastic feet, using a Phillips 00 screwdriver, remove the two back 11.6mm screws.

  • The hole is deeper than you may think. It may take some time to get the screwdriver to click in.

コメントを追加する

  • Carefully pull apart the bottom panel from the top panel.

  • Be careful not to pull too forcefully as the panels are connected by wires.

  • Beware of pencil shavings falling out onto your workspace.

コメントを追加する

  • Using a Phillips00 screwdriver, remove two 8.9mm flat edge screws from the top section of the top panel.

コメントを追加する

  • Using a Phillips00 screwdriver, remove two 10.3mm screws from the middle section of the top panel.

コメントを追加する

  • Carefully pull the cover from the top panel and set it aside.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Jen Hawkins

メンバー登録日: 2014年10月27日

408 ポイント

4のガイドは作成済み

チーム

Eastern Washington University, Team 1-5, Carnegie Fall 2014 Eastern Washington University, Team 1-5, Carnegie Fall 2014人のメンバー

EWU-CARNEGIE-F14S1G5

7 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 356